Fishing Knots (Very Very Simple)

Introducing a method that can be used when lure fishing with commonly used knots.

The knot method is to make two general knots, and twist the rope 3 to 5 times each time you make each knot.

Plain knot (twisted once)

Plain Knot (twice twisted)

Plain Knot (Twisted 5 times)

Tighten the knot neatly by pulling the end of the string. Finish by cutting a 2mm section on the side of the knot.

This is the second knot

Make a second knot and twist it 5 times.

Pull the main line while slowly arranging the line (be careful not to make the first knot line too long).

Finish by making the first knot touch the ring!

Caution !

Do not allow the line to be too long.

If number 2 is too long, a lot of heat will be generated when tightening the string, which can weaken the string.

You need to pull the string while arranging it so that the number 2 string remains as short as possible.

It is good to finish by pulling the line No. 1 when 5mm~1cm remains from the end.

I'm not familiar with the new knotting method, so I often forget it if I don't use it often.

This knot uses a very common knot.